UGENE Forum - Crash when adding a sequence to an alignment


	The UGENE forum has been switched into read-only mode. If you have any questions, comments, or concerns, please send an e-mail to ugene@unipro.ru. Thanks!

Home

UGENE Forum › General Category › Bugs and Issues › Crash when adding a sequence to an alignment

‹ Previous Topic | Next Topic ›

Pages: 1

Crash when adding a sequence to an alignment (Read 4809 times)

Mar 16^th, 2013 at 9:42am

Peter Offline
YaBB Newbies

Posts: 6

i have an alignment and I need to add an additional sequence I have obtained from Genbank

When I add the additional sequence using "Actions -> Add -> Sequence from ...." everything works fine
Similarly if I am in the Alignment View and use the right mouse to access "Add -> sequence from ....." everything is OK

But if i am in Project View and use the the right mouse to "Add -> Add object to document", and then choose the new loaded sequence...
Then UGENE crashes giving this message: "Exception with code c0000005 - Access violation::605a9360" and the attached log-file.
Thanks

Ugene_crash_report (8 KB | )

IP Logged

Reply #1 - Mar 18^th, 2013 at 1:30pm

Yuriy Vaskin Offline
Global Moderator

Gender:
Posts: 138

Peter,

I was going to write you since you left your email.

I wasn't able to reproduce that crash. In what file format do you store your alignment?

Thank you.

IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›