Welcome, Guest. Please Login or Register
UGENE Bulletin Board
  Welcome to our forum.
  HomeHelpSearchLoginRegister  
 
 
Page Index Toggle Pages: 1
Problem with SPAdes assembly (Read 1680 times)
Nov 2nd, 2023 at 7:52pm

Jesus   Offline
YaBB Newbies

Posts: 1
*
 
Hi, I am trying to assemble two .fq files obtained with illumina paired ends. This files already have been used to assemble contigs using Shovill of Galaxy, however, when I try to run an assembly with UGene, the pipe stops with the message "Subtask {GenomeAssemblyTask} is failed: Subtask {SPAdes tool} is failed: SPAdes tool exited with code 245". Can you give any advice, please?
 
IP Logged
 
Reply #1 - Nov 30th, 2024 at 12:43am

kimon58   Offline
YaBB Newbies
California

Posts: 4
*
 
Ensure that your .fq files are clean and do not have any errors in the data (e.g., quality control issues). You could run a QC step using tools like FastQC to check the quality of your reads before attempting assembly.
 
IP Logged
 
Page Index Toggle Pages: 1